Performance Tool W84600 High Energy Ignition Tester

Before connecting the Remote Starter Switch, the transmission gear lever must be in the Park position for automatics or Neutral position for manual transmissions and the parking brake set. Allows one person to start and crank the engine from either side of the vehicle. Exercise care when making this connexion because battery voltage is always present at the solenoid or starter relay. Personal injury may be caused if leads are shorted to a ground through tools, wires or wristwatch. Turn the ignition switch to the On position before using the Remote Starter Switch if you wish to start the engine. If the vehicle is equipped with an engine Hot indicator, the lamp test circuit which is in the ignition system could be damaged if the remote starter switch is energised with the ignition switch in the Off position. Key in the off position would be used if youre just cranking the engine over for special jobs like setting valves, or testing compression. This relay may have three or four terminals, two large ones and one or two small ones. 1. Remove the wires connected to the small terminal if only one small terminal is provided. If two small terminals are present, remove the wires from the small terminal marked S. 2. Connect one lead of the Remote Starter Switch to the bare small terminal where the wires were just removed. 3. Connect the other lead of the Remote Starter Switch to the Battery Terminal of the relay. 4. Crank the engine by depressing the Remote Starter Switch. This relay may have three or four terminals, two large ones and one or two small ones. 1. Connect one lead of the Remote Starter Switch to the small terminal of the solenoid marked S. Be cautious as these connexions are exposed and very close together. 2. Connect the other lead of the Remote Starter Switch large battery terminal on the solenoid. This is the heavy cable coming from the battery. 3. Crank the engine by pulling the trigger on the Remote Starter Switch.