Polyurethane Windshield Adhesive with Fast Curing Formula High Bond Strength Window Sealant Compound

This single-component glass repair glue sets the standard for optimal sealing and safety. This glass sealant meets the strength requirements set out by manufacturers for windshield replacement Effortless Application –– Get the job done right the first time with this medium viscosity auto glass adhesive that can be loaded into any standard caulking gun. The non-sag properties ensure that the compound doesn’t bleed for enhanced control Rapid Results –– Add weather-resistant protection that lasts. Tackle your auto glass project today with this quick cure urethane adhesive compound. Use this windshield glue that delivers a secure hold that you can count on For Every Auto Glass Project –– From convertibles to RVs, windshields to sidelights, this car window sealant has you covered. Immediate Strength Development br br This fast-curing automotive window glue boasts exceptional bonding power. br br One application of the glass adhesive glue is all it takes for permanent weather-resistant protection. br br From windshield and glass sealer to RV window sealant, this compound can do it all. br br Directions for Use: /b br br – Detach wipers and accents, then use a utility knife to slice through the current urethane sealer br – Remove existing glass with care, and carefully clean debris from all surfaces br – Align and dry set the new glass using tape strips for positioning. Once marked, remove the windshield br – Remove the majority of the old car glass adhesive from the pinch-weld, leaving only a small layer br – Apply single-step primer* to any bare metal and conduct any required abrasive cleaning br – Clean the interior surface where contact will be made with windshield and glass sealant br – Apply a thin layer of primer* around the edge and let dry br – Cut the applicator tip on the windshield leak sealant to desired size br – Directly apply this windshield mount adhesive over the old auto window sealant br – Position the glass using the tape markings, and press into place to complete contact br – Squeeze out extra urethane windshield adhesive, or fill voids if necessary br – Remove the tape alignment strips, reattach moldings, wipers, and other accents br – Finally, clean up any excess windshield urethane adhesive br br * To use without primer, ensure the bonding surface is free from contamination prior to application of the car windshield sealant. br The glass must also be pre-cleaned with a non-antistatic glass cleaner. br br Additional Instructions: Designed for use at an ambient temperature of 42-95 F. br Place the car windshield adhesive in a plastic bag and submerge it in hot water before use for best results.