Rok Glass Door Pivot Hinge for Free Swinging Glass Doors

FUNCTION: A hinge for inset-free swinging glass doors. Requires magnetic catch. Pressure screws will hold 1/4″ (6mm) thick glass securely in the hinge. EASY INSTALLATION: These pivot hinges for glass doors require no drilling of the glass. No-bore features using pressure plate and screw. Requires an 11/32″ (9mm) hole for pivot bushing. WIDE RANGE OF APPLICATIONS: Pivot hinges for cabinet doors, shower, mirror, medicine cabinets, bathroom vanity, and much more. STYLISH: Have these stark, sleek and modern glass cabinet door hinges in Brass finish. Also available in Black Zinc Plated or Chrome finish. SET INCLUDES: 2x Hinges (L&R), 2x bushings, 2x plates, 4x screws. For glass thickness 3/16″ (5mm) to 1/4″ (6mm) Use this hinge to insert glass to create a free-swinging glass door. This pivot hinge requires no drilling of the glass and is simple to install. br With strike plates br With metal screws br Set includes: br 2x Hinges (L&R), 2x bushings, 2x plates, 4x screws br br Features: br Use on inset doors only br Pressure screws will hold 1-1/4″ (32mm) thick glass securely in the hinge. For glass thickness: 3/16″ (5mm) – 1-1/4″ (32mm) br Requires an 11/32″ (9mm) hole for pivot bushing br Requires Magnetic catch/Magnastrike br No-bore features using pressure plate and screw! br br Installation: br 1. Locate bushing centers. The hole is to be located at 12mm approx (15/32″) from inside of cabinet face. The amount of inset is optional. The hole diameter is 9mm by 10mm deep. (11/32″ (9mm) + dia. x 25/64″ deep approx.) br br 2. Drill pivot bushing holes. A metric brad point drill set should be used. Assemble cabinet. Then place hinges in bushings. Measure the vertical distance from bottom to top hinge. This is a measurement inside the hinge pieces. Deduct 2mm from this dimension for clearance. br br 4. Cut glass for foregoing proceeding instructions. br br 5. Peel the paper from pressure plates. Set pressure plates to the inside corner faces of doors. Place lower hinges into bushings. Slide door into the hinge. The door should open outward approximately 60 degrees. Place the upper hinge into bushings and slide the upper corner of the door into the hinge. Make an approximate lateral setting of the hinge on the door corner, and set one screw in each hinge. Test closing door to check side clearance from door to inside face of the cabinet. If necessary, loosen screws to make vertical adjustments so that door fits into the cabinet opening with proper side clearance. br br